What “laser-ready” means here
Closed outlines only, so nothing is left as an open line that the laser skips. Cut lines are red and engrave areas are black, a common layer set-up in LightBurn and other laser software.
The Cut-Ready Check flags features thinner than about 0.3 mm, which tend to burn away.
Good inputs for laser work
High-contrast logos, line art, lettering and silhouettes work best. Line art like the mandala above keeps every ring closed. For photo engraving with full tonal detail, use your laser software’s image mode instead of vectors.
Which file for which laser
LightBurn and xTool Creative Space read both SVG and DXF; the Glowforge app reads SVG. Machine-by-machine notes: LightBurn, xTool, Glowforge.
Before you press start
Measure your kerf once per material: cut a 20 mm square, measure it with calipers, and the missing width is your kerf. Enter that on the download page and the laser-ready file grows each outline by half of it, so tabs, inlays and box joints fit.
Then check the size. A design traced from a picture has no real size until you give it one, so set the final width in millimetres in the converter or on the download page. Finally, run a test on scrap with the same settings. Lasers are fast, materials are not free.
Materials and what to watch
- Plywood and MDF: cut and engrave well; glue layers in plywood can char, so test cut depth first.
- Acrylic: CO₂ lasers cut it with polished edges; diode lasers cut dark acrylic only.
- Leather and card: fine detail is possible, but keep thin parts above about 0.5 mm so they do not tear.
- Never laser PVC or vinyl: it releases chlorine gas that harms you and the machine.
Last updated