SVG or DXF in xTool Creative Space
xTool Creative Space imports both SVG and DXF. The SVG keeps your colours, which makes it easy to assign cut and engrave settings per colour. The DXF carries the outlines only and is handy if you also use CAD software.
If you run your xTool from LightBurn instead, both files work there too; see files for LightBurn.
Even “transparent” images from the web
The penguin above was downloaded as a fake transparent PNG: the grey-and-white checkerboard is painted into the picture. We recognise that pattern and treat it as empty space, so you get the penguin, not the checkerboard.
Fit, kerf and small parts
For inlays, boxes and puzzles, set the kerf on the download page and every outline grows by half of it. Keep thin features above about 0.3 mm on wood. Diode lasers usually have a slightly wider kerf than CO₂ lasers, so measure yours with a test square.
Diode or CO₂: what changes
Diode lasers like most xTool models cut wood and dark acrylic well and engrave almost anything, but they cannot cut clear acrylic and are slower on thick material. That affects design rather than the file: on a diode laser, keep thin parts a little wider and leave more space between cuts, because the beam is wider and heat spreads further.
The files themselves are the same for every xTool machine, and the same files work with other lasers too.
| Laser and material | Start with |
|---|---|
| Diode, 3 mm plywood | 0.15–0.2 mm |
| CO₂, 3 mm plywood | 0.1–0.15 mm |
| CO₂, 3 mm acrylic | 0.1–0.2 mm |
Last updated