Why stencils need bridges
A stencil is the material that remains after the design is cut away. Any part of the design that fully encloses material creates an island that drops out when you lift the stencil.
The Cut-Ready Check counts those islands and the bridge tool connects each one with a thin strip, 1.5 mm wide by default. You can set the width before you save.
Tips for clean stencils
A few choices make the difference between a crisp stencil and a frustrating one:
- Choose one colour. The design is one shape cut out of the sheet.
- Use a bold font or a high-contrast image; thin strokes tear.
- Keep bridges at least 1.5 mm for Mylar stencil film and wider for paint rollers.
- Leave a margin of material around the design so the sheet stays strong.
Materials and machines
The stencil SVG works on Cricut and Silhouette for stencil vinyl and Mylar, and the DXF on lasers for cardboard, plastic or thin plywood stencils. For laser-cut stencils, also set a kerf on the download page.
Stencil or design? Positive and negative
When you cut a stencil, the design is the hole. The paint goes through where the letters are, so what you keep is the sheet around them. That is why enclosed parts need bridges: the middle of an O is part of the sheet, and without a bridge it has nothing to hold on to.
If you want the opposite, solid letters to paint around, use the normal cut file instead and weed the background. Both come from the same purchase, so you can cut whichever suits the project.
| Use | Bridge width |
|---|---|
| Adhesive stencil vinyl | 1.5 mm |
| Mylar, spray paint | 2 mm |
| Paint roller on walls | 3 mm or more |
| Laser-cut card or plywood | 2–3 mm |
Last updated